WLFH Foil Installation

Step 1
Before installing, draw an installation plan showing the placement of the mats, floor sensor, and junction box or boxes. The Warmup Foil heating system should cover at least 80-90% of the floor area of your room to be used as a primary heat source.
Step 2
Clean all debris from the floor base and place the insulation pads or boards as per the manufacturer´s instructions. And then clean all debris from the surface of the insulating material.
Step 3
Roll out the Foil Heating panels on top of the insulating material. Ensure that each heating panel is completely flat. Make sure that the cold leads are on the side of the panel that is closest to the location of the electrical junction box.
Step 4
Stretch the Foil heating panels and secure them to the floor with the aluminium tape. Where required, additional duct tape can be used. Tape the sensor down with masking or box tape, positioning it in-between element wires of the foil system. Run the sensor cable off the heater and back to the thermostat in the same channel as the power supply cables.
Step 5
Measure the resistance of the foil heating system and record the value. Verify that the values you measure are in line with the resistance values that are printed on the installation manual.
Step 6
Switch off the Foil heater and disconnect the thermostat from the supply when fitting the flooring.
© Warmup Plc | Electric Floor Heating IE 205
205