Warmup® Mirror Demister

Warmup® Mirror Demisters are a technologically advanced, permanent, safe and simple solution for steamed up mirrors - ideal in the bathroom.

FEATURES

• Flat film does not take up space
• Self-adhesive for convenient installation directly onto the back of the mirror
• Connects to existing room light circuit for automatic operation when light is switched on
• Suitable with most types of mirrors, existing or newly installed
• Can be used in combination for larger areas
• Resistant to moisture, vibration, shock, dust and ageing
• SEMKO approved, CE mark

Ensure that the mirror demister is of a correct size for the mirror - a 10mm gap between the edges of the mirror and the demister should remain after installation.

Check that the selected mirror is fit for purpose for eg. the mirror should be completely flat and free of crack lines.

NO accessories or other materials should be fixed to the mirror surface as this can create uneven temperatures and stress upon the mirror.

It is recommended that a mirror with tempered glass is used, as some other mirrors may crack due to operational temperatures. Check with the manufacturer if you are unsure.

Fitting

Mark the position of the demister on the back of the mirror and apply the self-adhesive heating film with firm, even pressure (ensure no air bubbles are trapped at any time).

Position the connector block that is attached to the heater, and if necessary, cut a recess in the wall for a flush fit.

Affix mirror to the wall as per mirror manufacturer`s guidelines, ensuring that no cables or connectors are trapped behind the mirror.

The heater can either be connected directly to a switched light circuit, which will activate the demister when the light is switched on, OR via a separate switch connected to the main lighting circuit.

Final connections should be made by a certified electrician.

Larger mirrors

If more than 1 mirror demister is to be installed for the same mirror, wiring MUST be in parallel.